Frigidaire refrigerator not cooling
Often a failed evaporator fan, dirty coils, or defrost fault
When your Frigidaire fridge runs but won't stay cold, food safety is on the line. We trace the problem from airflow through the sealed system.
How we fix it
- We test the evaporator and condenser fans and replace any that have failed.
- Condenser coils are cleaned and the defrost system is checked for frost buildup.
- If the compressor or sealed system is involved, we diagnose it before recommending repair.
We restore steady cooling so your groceries stay fresh and the fridge stops straining.
Frigidaire dryer not heating
Usually a heating element, thermal fuse, or thermostat failure
A Frigidaire dryer that tumbles but stays cold has a break somewhere in the heat circuit. We check the entire chain and the airflow path.
How we fix it
- We test the heating element or gas igniter for continuity and proper operation.
- Thermal fuses and thermostats are checked, since a blown fuse cuts heat completely.
- The vent and lint path are cleared, as restricted airflow trips safety components.
With heat restored and airflow verified, your dryer finishes a load in one cycle again.
Frigidaire oven not heating to temperature
Commonly a bake element, igniter, or temperature sensor
When your oven won't reach or hold the set temperature, baking suffers. We pinpoint the failed component and calibrate the oven back to spec.
How we fix it
- We test the bake and broil elements, or the gas igniter, for proper function.
- The temperature sensor is checked for accuracy and replaced when it reads incorrectly.
- A faulty control board is identified when it disrupts the heating cycle.
Once repaired, your Frigidaire oven holds temperature and bakes evenly again.
Frigidaire dishwasher won't drain
Usually a clogged filter, drain hose, or failed pump
Standing water in the bottom of your dishwasher points to a blockage or a pump problem. We work through every part of the drain path.
How we fix it
- We clean the filter and check the drain hose for clogs and kinks.
- The drain pump is tested and replaced if it isn't engaging properly.
- The air gap and disposal connection are verified to ensure free drainage.
We clear the blockage so your dishwasher drains fully and finishes its cycle.
Frigidaire washer won't spin or drain
Often a clogged pump, worn belt, or lid-switch fault
A washer that leaves clothes soaking wet has a clog or failed component in the drain and spin system. We check each likely cause in order.
How we fix it
- We inspect and clear the drain pump and filter of debris and lint.
- The lid switch and door lock are tested, since spin won't start without them.
- The drive belt and motor coupling are checked and replaced when worn.
We get your Frigidaire washer spinning strong so laundry comes out ready to dry.